Warning - This property listing has now expired.

Any changes made to the content of this listing WILL NOT BE SAVED. However, you can still change the property status (i.e. available/sold/let etc).

To renew this property or for further assistance please call 01767 313380 or email renewals@novaloca.com.

Unit E1, Ford Airfield Industrial Estate, Ford, Arundel, BN18 0HY

994 Sq Ft / Industrial / General Industrial

To Let - £14,000.00 per annum

Available - Last updated: 01 September 2025

The unit forms part of a block of modern light industrial units. The unit has brick and blockwork walls and part profiled sheet cladding under an insulated profile lined roof with translucent roof lights. There is a roller shutter loading door at the front of the unit as well as a separate pedestrian entrance. The under has an uninterrupted eaves height of approximately 5.38m.

The unit is situated on the southern side of the Ford Airfield Industrial Estate.

Ford is approximately two miles to the northwest of Littlehampton and three miles to the east of Bognor and Arundel four miles to the north. Ford Airfield Industrial Estate is at the southern end of the village of Yapton and is approximately 3 miles south of the A27 south coast trunk road and 1 mile to the north of the A259 coast road via Yapton Road (B2233).

( Agency Pilot Software ref: 5735 )

Property Quote Price(s)

DescriptionSale typeGuide pricePrice type
  To Let £14,000.00 per annum

Email me updates about similar new properties


Show similar properties

Thank you for your enquiry

The agent for this property will get back to you as soon as possible.

Would you like to view similar properties now?

Many thanks, your enquiry has been sent to the agent

In response to the boxes you ticked, we'd like to send you emails about new & updated properties based on the following (please amend as required):


Please note, NovaLoca will only contact you about commercial property & you can unsubscribe at any time. Your information will not be given to third parties without your permission. For more information please refer to our privacy policy.